Tuesday, September 15, 2020

Fiberglass Cloth

 Cutting Cloth to fit

After a lot of filling and sanding of the bottom I have begun the process of fiberglassing the bottom. The fiberglass cloth has been draped over the boat and trimmed to fit. Tomorrow I will wet it out with epoxy.




Next Step

Wet out the fiberglass cloth with epoxy. 

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Ready to Launch

  Finished Product Fittings installed in bow and stern decks. The Water Rat is all finished, named, and ready to launch. I am still working ...

  • Getting Started
     The plans say all panels may be laid out on two sheets of 4X8 plywood with the very crowded nesting diagrams shown. The plywood I'm usi...
  • Painting the Bottom
     Finally Painting Painting covers a multitude of sins but also reveals some areas that need a little more sanding. So I will sand some more ...
  • Marking the Lines
      Taking Shape Very tedious work - plotting points to 1/16 inch, driving finishing nails into them, curving the long batten I made yesterday...